MAG5.
INSTRUCTION MANUAL MAG5.1R SYSTEM IMPORTANT SAFETY INFORMATION • The amplifier has been exposed to rain. You should always follow these basic safety precautions when using your Sonance MAG5.1R, to reduce the risk of fire, electric shock, and injury to persons: • The amplifier does not appear to operate normally or exhibits a marked change in performance. • The amplifier has been dropped, or the enclosure damaged. 1.
INTRODUCTION strong bass that sounds clear (without boominess) at the seating locations while maintaining the sound’s impact. Thank you for purchasing MAG5.1R. When properly installed your new speakers will give you years of entertainment pleasure. Your local authorized Sonance dealer is an expert in audio/video system planning and installation. We strongly recommend that you work with your dealer to ensure that you get the best performance possible from your subwoofer. BOX CONTENTS MAG5.
MS8 SUB - CONNECTION 3. Make sure all the Roto-Lock toggle feet are retracted so that they are tucked within the mounting hole’s border. Insert the speaker into the hole in the ceiling (Figure 3). The RotoLock system can accommodate a ceiling material thickness of 1-1/2” (38mm). 4. Tighten the screws on the front of the speaker baffle. The Roto-Lock toggle feet will automatically rotate into position and begin clamping the speaker (Figure 4).
MS8 SUB - VOLUME CONTROL The volume control on the rear panel of the MS8 SUB (figure 7) should normally be set to the MAX or FULL CLOCKWISE setting. 1 A/V home theater receivers have built in settings for volume level for subwoofer and satellite speakers. The settings for the volume volume can be adjusted in the on screen menu for your A/V home theater receiver. By setting the MS8 SUB in this way the correct output level will be applied in your A/V home theater receiver and not in the subwoofer.
MAG5.1R SPECIFICATIONS MAG6R SPEAKERS Tweeter: 1” (25mm) silk dome, Ferrofluid-cooled, pivoting, in acoustic back chamber Woofer: 6 1/2” (165mm) glass fiber cone, rubber surround, pivoting Frequency Response: 45Hz – 20kHz ±3dB Imedance: 8 ohms nominal; 6 ohms minimum Power Handling: 5 watts minimum; 125 watts maximum Sensitivity: 89dB SPL (2.83V/1 meter) Grille: Perforated steel Dimensions (Dia.xD): 9 3/4” x 4 3/4” (248mm x 121mm) Cut-Out Diameter: 8 1/4” (210mm) Weight: 3.7 lbs (1.
LIMITED ONE (1) YEAR WARRANTY Sonance warrants to the first end-user purchaser that this Sonance-brand product (“Product”), when purchased from an authorized Sonance Dealer/Distributor, will be free from defective workmanship and materials for the period stated below. Sonance will at its option and expense during the warranty period, either repair the defect or replace the Product with a new or remanufactured Product or a reasonable equivalent.
©2020 Sonance. All rights reserved. Sonance and FastMount are registered trademarks of Dana Innovations. Due to continuous product improvement, all features and specifications are subject to change without notice. For the latest Sonance product specification information visit our website: www.sonance.com SONANCE • 991 Calle Amanecer • San Clemente, CA 92673 USA PHONE: (949) 492-7777 • FAX: (949) 361-5151 • Technical Support: (949) 492-7777 www.sonance.com 8 01.31.
