M AG 6 .
TABLE OF CONTENTS Introduction 3 Box Contents 3 Speaker Layout Planning 3 Types of Wire 4 Speaker Installation 4 Connecting the Speakers 4 Recommended Tools 5 Speaker Wire Connection 5 Connecting the Speaker Using a 2-Conductor Wire or Low Voltage Lighting Wire 6 Subwoofer Speaker Wire Connection 7 Specifications 7 Warranty 8 2
Introduction The satellite speakers should be placed from 8 to 10 feet (2.4 - 3.1 meters) apart for best coverage. To achieve the best balance between the satellites and subwoofer, the subwoofer should be placed as close to the center of the satellites as possible. Thank you for purchasing the MAG6.1 SYSTEM. When properly installed, this system will provide you with years of outdoor entertainment pleasure.
Types of Wire 4. Once the speakers and subwoofer are laid out in their locations and the wiring is completed per this installation guide, stake or mount the speakers into their final locations and bury the subwoofer in its final location. Color-coded, 14/4 direct-burial speaker wire is recommended. NOTE: PLEASE REFER TO THE WIRING CHART BELOW TO DETERMINE WHICH SIZE WIRE TO USE OVER A GIVEN DISTANCE. DISTANCES LISTED ARE FROM THE AMP TO THE FURTHEST SPEAKER.
Recommended Tools Speaker Wire Connection Connecting the speakers using 14/4 direct burial speaker wire. 1. Pull the 14/4 wire on the spool to the furthest speaker location. Leave the wire attached to the spool until the last speaker has been connected. 2. Starting at the last speaker and every speaker that follows, create a loop of wire approximately 6” in length. Wire Stripper accommodates up to a 12 gauge wire 3.
Connecting the Speakers Using a 2-Conductor Wire or Low Voltage Lighting Wire 1. Pull the first pair of 2-conductor wire to the furthest speaker location, leaving it connected to the spool near the amplifier. 2. Starting at the furthest speaker and every other speaker that follows, create a loop of wire approximately 6” in length, securing the loop with a wire tie. 6. Strip off 3/4 inch of insulation on the red and black wires to expose the copper conductor.
Subwoofer Wire Connection The subwoofer features a dual voice coil driver with 4 wires, one pair for each of the amplifier channels. red (+) and black (-) are used for the right channel, white (+) and green (-) for the Left channel. The subwoofer can be connected at any point along the daisy chain e.g. beginning, middle, end or anywhere in-between. However, locating the subwoofer mid-way in the daisy chain will produce an equal amount of bass for the speakers on either side of the sub.
LIMITED ONE (1) YEAR WARRANTY Sonance warrants to the first end-user purchaser that this Sonance-brand product (“Product”), when purchased from an authorized Sonance Dealer/Distributor, will be free from defective workmanship and materials for the period stated below. Sonance will at its option and expense during the warranty period, either repair the defect or replace the Product with a new or remanufactured Product or a reasonable equivalent.
