User Manual

6
6. Strip o 3/4 inch of insulation on the red and black
wires to expose the copper conductor. Combine and
twist the red wires from the amplifier, the first satellite
and the wire running to the next speaker in a
clock-wise motion.
7. Secure these three wires using the provided silicone
filled wire nuts, ensuring that NO COPPER is exposed.
8. Wrap the wire nut and surrounding wire connection in
electrical tape to protect from moisture.
9. At the next speaker, repeat steps 2 – 8 for the left
channel using the white (+) and green (-) leaving the
red (+) and black (-) wires intact.
10. Continue the above steps for the remaining satellite
speakers in the daisy-chain.
Connecting the Speakers Using a
2-Conductor Wire or Low Voltage
Lighting Wire
1. Pull the first pair of 2-conductor wire to the furthest
speaker location, leaving it connected to the spool near
the amplifier.
2. Starting at the furthest speaker and every other speaker
that follows, create a loop of wire approximately 6”
in length, securing the loop with a wire tie.
3. Cut the wire at the last speaker location in the
daisy-chain closest to the amplifier.
4. Take the spool back to the starting point and pull a
second 2-conductor wire to the furthest speaker
location and repeat steps 1 and 2 (see Figure 4).
5. Starting with the first speaker, cut the wire loop.
6. Strip the insulation on each wire to expose
approximately 3/4” of copper. Combine and twist all
the positive (+) wires together in a clockwise motion.
Repeat this step for all the negative (-) wires.
7. Secure the three wires together using the provided
silicone filled wire nuts ensuring that NO COPPER
is exposed.
8. Wrap the wire nut and surrounding wire connection in
electrical tape to protect from moisture.
9. Repeat steps 5– 8 for the remainder of the speakers.
To speaker
To next speakerFrom amp
IMPORTANT: BE SURE ONLY 3 SATELLITE SPEAKERS
ARE CONNECTED TO EACH AMP CHANNEL;
MIS-WIRING MAY RESULT IN AN UNACCEPTABLE
LOAD WHICH COULD DAMAGE YOUR AMPLIFIER.
NOTE: IF NOT USING COLOR-CODED WIRE, NOTICE
THAT ONE OF THE WIRES OUT OF THE PAIR WILL
HAVE A DIFFERENT TEXTURE OR PRINTING ON IT.
THIS WILL HELP IDENTIFY AND SEPARATE THE (+)
FROM THE (-). FOR SIMPLICITY, USE THE WIRE WITH
TEXTURE OR WRITING AS THE (+) AND THE OTHER
AS THE (-). USE THIS POLARITY STANDARD WHEN
CONNECTING ALL THE SPEAKERS.