Instructions/Assembly Guide

INVISIBLE SERIES NARROW SOUND ISOLATING ENCLOSURE

INSTALLATION INSTRUCTIONS

INTRODUCTION

Sonance Invisible Series Narrow Sound Isolating

Enclosures reduce sound transmission into rooms

that are adjacent to speakers mounted in walls or

in ceilings. For the enclosures to be eective, it

is important that they are installed according the

following directions to ensure a tight seal with the

speaker.

INSTALLATION

Step 1

Place the speaker on a ﬂat surface. Route the wire

from the IS speaker through the air tight connector

on the enclosure. You might need to loosen the nut

on the air tight connector to allow the wire to pass

through easily.

Step 2

Place the enclosure over the back of the speaker. Use

the provided self tapping screws to attach the

enclosure to the speaker while applying light pressure

to the back of the enclosure to ensure an air tight seal.

To ensure that the gasket sits properly, tighten the

screws in a crisscross and diagonal pattern. Apply an

equal amount of torque to each screw.

NOTE: SCREWS ARE #6x1” FLAT HEAD TYPE.

IMPORTANT: ALWAYS USE LOW-TORQUE

SETTINGS. NEVER OVER TIGHTEN.

Step 3

Tighten the nut on the air tight connector to seal up

the enclosure and capture the speaker wire. Connect

the wires from your ampliﬁer to the speaker wires

normally.

NOTE: ALL NARROW SOUND ISOLATING

ENCLOSURES INCREASE THE MOUNTING DEPTH OF

THE INVISIBLE SERIES SPEAKERS TO 7.67” (195MM).

MODELS IS8T AND IS15W INCLUDE THE ENCLOSURE

BUILT IN AND DO NOT REQUIRE THIS ACCESSORY.

NOTE: THE MOUNTING WIDTH OF ALL NARROW

SOUND ISOLATING ENCLOSURES IS 10.43” (265MM).

ALL MODELS ARE DESIGNED TO BE USED WITH 16”

(406.4MM) ON CENTER TJI JOIST SPACING.

Note: Contact Sonance Technical Support for replacement screws.

For additional information

please scan the code.

PAGE 1
INVISIBLE SERIES NARROW SOUND ISOLATING ENCLOSURE INSTALLATION INSTRUCTIONS INTRODUCTION Sonance Invisible Series Narrow Sound Isolating Enclosures reduce sound transmission into rooms that are adjacent to speakers mounted in walls or in ceilings. For the enclosures to be effective, it is important that they are installed according the following directions to ensure a tight seal with the speaker. INSTALLATION Step 1 Place the speaker on a flat surface.
PAGE 2
LIMITED FIFTEEN (15) YEAR WARRANTY Sonance warrants to the first end-user purchaser that this Sonance-brand product (“Product”), when purchased from an authorized Sonance Dealer/Distributor and installed by a Sonance installer, will be free from defective workmanship and materials in the initial installation for the period stated below.