OMNI-6T OMNIDIRECTIONAL OUTDOOR SPEAKER INSTRUCTION MANUAL
Omnidirectional Outdoor Speaker IMPORTANT SAFETY INSTRUCTIONS OMNI-6T This product is intended to be installed by professional AV integrators and installers only. This product manual is intended to serve as a general guideline for most applications. It is the installer’s responsibility to ensure this product is installed in accordance with local building codes and regulations.
PRODUCT DESCRIPTION PRODUCT FEATURES The Sonance OMNI-6T In-Ground Omnidirectional Speaker utilizes a unique, perimeter-firing driver array paired with an up-firing 6.5” woofer in a discreet, weatherized housing. Exceptional omnidirectional coverage is achieved while maintaining fidelity throughout the midrange and treble via direct radiation of the four wide-band canopy drivers.
PRODUCT PREPARATION INSTALLATION AMPLIFIER SELECTION When choosing an amplifier, the maximum number of speakers and the output level of each speaker must be known. The sum of the tap settings should never exceed 80% of the amplifier’s rated output. For example, if there are 5 speakers and the taps are set at 20 watts, the load would be 100 watts (5 x 20 watts = 100 watts). To arrive at the needed power for this number of speakers, simply divide the total load by 0.8. In this case, 100 / 0.8 = 125 watts.
the four 1/4” (6mm) mounting holes in the base to secure the speaker onto its installation surface (stainless steel mounting hardware not included). 2. Prepare the wires to be connected by stripping back the insulation to expose approximately 1/2” of copper. Combine the positive (+) wires from the amplifier, the speaker, and the line running to the next speaker.
SONANCE DSP2-750 S/N CAUTION MADE IN CHINA RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS 2-L 2-R IN IR CONTROL IR STATUS VOLTAGE TRIGGER 1- RIGHT 1- LEFT IN OUT 3-30 VOLTS AC or DC BRIDGE 8 ΩMIN CLASS 2 WIRING T15AL / 250VAC CAUTION REPLACE FUSE ONLY WITH SAME TYPE AND RATING ATTENTION REMPLACER UNIQUEMENT AVEC LE MEME TYPE ET CALIBRE DU FUSIBLE IN OUT AC 100-120V ~ 60Hz AC 220-240V ~ 50Hz OUT TCP/IP DHCP ON - DEFAULT Figure 7: Wire Jacket Removed + + - - To Next Speaker 1-R 275 watts
12” (305mm) 8.67” (220mm) 14.5” (368mm) 4.86” (123mm) Bury 6–8” (150–200mm) 11.36” (289mm) SPECIFICATIONS Frequency Range (-10dB) 35Hz – 25kHz Frequency Range (-3dB) 60Hz – 20kHz Power Capacity 120 Watts Continuous Program Power | 60 Watts Continuous Pink Noise Nominal Sensitivity 88 dB Nominal Coverage Angle 360 Degrees Hortizontal Coverage, 160 Degrees Vertical Coverage Rated Maximum SPL 107dB @ 1 Meter (3.
OMNI-6T ARCHITECTURAL SPECIFICATIONS TECHNICAL ASSISTANCE AND SERVICE 70V/100V/8 Ohm Selectable 6.5” Omni-Directional Outdoor Loudspeaker The Technical Assistance Department at Sonance is available at (949) 492-7777 to answer any questions concerning the operation and installation of your speakers between the hours of 7:00 AM and 5:00 PM Pacific time, Monday through Friday, except holidays. The loudspeaker shall deliver 360 degrees horizontal, 160 degrees vertical coverage and consist of a 6.
LIMITED FIVE (5) YEAR WARRANTY Sonance warrants to the first end-user purchaser that this Sonance-brand product (“Product”), when purchased from an authorized Sonance Dealer/Distributor, will be free from defective workmanship and materials for the period stated below. Sonance will at its option and expense during the warranty period, either repair the defect or replace the Product with a new or remanufactured Product or a reasonable equivalent.