User Manual
5
Adjusting Width Models Only
Included with your soundbar is a pair of black textured opaque
strips (included with Adjustable Width Soundbar models only:
SB46 L and SB46 M). These are used to cover the remaining open
area where the lock screw slides through. In some conditions light
may pass through this area into the grille. Peel o the adhesive
backing and place the strip over the open area and cut to size.
The radius side ts against the lock screw.
Wiring The Soundbar (All Models)
We suggest leaving extra wire length to make it easy to connect the
wire to the Soundbar spring terminals prior to mounting the display.
The extra wire can then be pushed back into the wall.
1. Strip 1/4” – 1/2” (6 – 12mm) of insulation from each speaker
lead. Twist the strands or tin the exposed wire with solder to
ensure that there are no stray strands.
Opaque Strip
Adjusting Grille Width
3. The Sonance Soundbar’s six terminals are spring-loaded.
Push the top of each terminal down to open the connector and
insert the exposed wires into the holes in the spring terminals.
The speaker’s positive spring terminals are labeled with a red
dot; the negative spring terminals are labeled with a black dot.
Double-check that you connected amplier “+” to speaker “+”
and amplier “–” to speaker “–”on all three channels.
Stereo Wiring
If you are using a 2 channel amp or stereo receiver only hook up
the left and right channels of soundbar. Connect AC power and
video cable to display.
NOTE: FOR ADJUSTABLE WIDTH SOUNDBAR MODELS ONLY:
SB46 L |SB46 M
Be sure to complete this step prior to attaching the display and
soundbar to wall mount bracket. Adjust the side grilles of the
soundbar to achieve perfect symmetry with the display. Loosen the
rear lock screw on each side grille and slide the grille out to match
the width of the display. No tool required. Once the width is set
tighten the lock screws nger tight.
NOTE: STRAY STRANDS THAT TOUCH EACH OTHER CAN CAUSE A
SHORT-CIRCUIT THAT CAN DAMAGE THE AMPLIFIER.
2. Bend the speaker wires into an L. for easy connections to the
spring terminals.