SONANCE GARDEN SERIES SATELLITE SPEAKERS I N ST R U C T I O N M A N UA L
Introduction Use care to select satellite locations that are equally distant from the main listening area. When possible, use high and low locations to centralize the acoustic stage. See Figure 2. Thank you for purchasing Sonance Garden Speakers. When properly installed, these speakers will provide you with years of outdoor entertainment pleasure. To get the most out of your new speakers, please read this manual thoroughly before you begin installation.
NOTE: ATTENTION MUST BE PAID TO THE ELECTRICAL LEADS TO AVOID NICKS AND CUTS THAT MIGHT SHORT THE SYSTEM. Waterproof Wire Nuts 3. Prepare individual leads to be connected to main leads. Positive Negative - + 4. Dig a 4” – 5” deep trench for running the speaker wires. 5. Run the wire through the trench from the amplifier to the first speaker location. Twist wires together 6.
Specifications Model: SGS SAT Tweeter: 3/4” (19mm) polyurethane dome Woofer: 3.5” (89mm) Anodized aluminum cone & Santoprene™ surround Frequency Response: 80Hz - 20KHz ±3dB Enclosure Material: Non-corrosive, high-heat ABS sealed enclosure Dimensions: (Length x Diameter) 6.5” L x 4.5” Dia. (165mm x 114.8mm) Shipping Weight: 5.0lbs (2.4kg) each 16.47” (418.28mm) 4 1/2” (114.
LIMITED THREE (3) YEAR WARRANTY Sonance warrants to the first end-user purchaser that this Sonance-brand product (“Product”), when purchased from an authorized Sonance Dealer/Distributor, will be free from defective workmanship and materials for the period stated below. Sonance will at its option and expense during the warranty period, either repair the defect or replace the Product with a new or remanufactured Product or a reasonable equivalent.