I N S T R U C T I O N M A N UA L SONAMP® MULTI-CHANNEL POWER AMPLIFIERS 2-100 & 12-50
INSTRUCTION MANUAL SONAMP® 2-100 & SONAMP® 12-50 MULTI-CHANNEL POWER AMPLIFIERS Important Safety Information You should always follow these basic safety precautions when using your Sonamp 2-100 or Sonamp 12-50, to reduce the risk of fire, electric shock, and injury to persons: • The amplifier has been exposed to rain. • The amplifier does not appear to operate normally or exhibits a marked change in performance. • The amplifier has been dropped, or the enclosure damaged. 1.
SONAMP 2-100 & 12-50 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL I N S T R U C T I O N S I M P O R TA N T E S C O N C E R N A N T L A S É C U R I T É 10. Protégez le câble d’alimentation secteur de telle manière qu’il ne puisse pas être écrasé ou pincé, particulièrement au niveau des prises, du passage dans des goulettes prévues à cet usage, ou à l’endroit où il sort de l’appareil. 1. Lisez soigneusement ces instructions. 2. Conservez-les en lieu sûr pour toute référence future. 3.
SONAMP 2-100 & 12-50 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL Introduction Box Contents Thank you for purchasing the Sonance Sonamp 2-100 or 12-50 amplifier. When properly installed, this amplifier will give you many years of entertainment pleasure. To get the most out of your new amplifier, please read this manual thoroughly before you begin installation.
SONAMP 2-100 & 12-50 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL FIGURE 3: SONAMP 2-100 MULTI-CHANNEL AMPLIFIER 1L 1R 2-100 1 4 1-R LEVEL IN RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS ON RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR VOLTAGE TRIGGER IN OUT 5 7 OFF 3-30 VOLTS AC or DC 10 T5AL / 250VAC AUDIO BRIDGE 8 Ω MIN CLASS 2 WIRING AUTO ON VOLTAGE 1 - RIGHT 1 - LEFT OUT CAUTION 2-100 LEVEL BRIDGE OFF 9 52 watts 1-L 2 6 CAUTION REPLACE FUSE ONLY WITH SAME TYPE AND RATING AC 1
SONAMP 2-100 & 12-50 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL 1L 1R 1L 1R 2L 2R 3L 3R 4L 4R 5L 2-100 LEVEL 1-RIGHT 2-LEFT 2-RIGHT 6R 3-LEFT 3-RIGHT 4-LEFT 4-RIGHT 5-LEFT 5-RIGHT 6-LEFT 12-50 6-RIGHT RISK OF ELECTRIC SHOCK DO NOT OPEN S/N AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR VOLTAGE TRIGGER IN OUT CAUTION BUSS INPUT A LEFT IN LEFT OUT IN LEVEL BRIDGE MONO STEREO LOCAL BUSS A BUSS B LEVEL LEVEL ON BRIDGE OFF MONO STEREO LOCAL BUSS A BUSS B LE
LEVEL 2-100 Powering the Amplifier ON Source Connections/Selection 12-50 AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR OFF BRIDGE 8 MIN CLASS 2 WIRING AUDIO VOLTAGE 1 - RIGHT CAUTION REPLACE FUSE ONLY WITH SAME TYPE AND RATING ATTENTION REMPLACER UNIQUEMENT AVEC LE MEME TYPE ET CALIBRE DU FUSIBLE Each time the amplifier’s power cord is initially plugged in and the POWER switch is turned ON, all channel outputs are disconnected for approximately 12 seconds and all PROTECTION LEDs will illuminate br
1-LEFT 2 SONAMP 2-100 & 12-50 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL Source Connections 2-100 Bridging Channels 2-100 & 12-50 STEREO MONO STER STEREO IMPEDANCE MONO FOR IMPORTANT: THE MINIMUM SPEAKER On the left side of the 2-100 rear panel are the audio inputs for the BUSS INPUT A BUSS INPUT B BRIDGED OPERATION IS 8 OHMS. DO NOT OPERATE A ZONE left and right channels.
SONAMP 2-100 & 12-50 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL Protection Circuitry and LEDs Rack Ear Installation 12-50 The Sonamp amplifiers have a multi-stage protection system to prevent damage to your amplifier and speakers. The 12-50 ships with two short rack ears. Unscrew the four Phillips head screws found on each side of the left and right forward section of amplifier. Use these screws to connect the included rack ears to the amplifier (see Figure 17).
SONAMP 2-100 & 12-50 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL SPECIFICATIONS SONAMP 2-100 Number of Channels 2 (1 stereo pair) Power Output - 8 ohms (Stereo) 100 Watts RMS per channel (all channels driven) Power Output - 4 ohms (Stereo) 156 Watts RMS per channel (all channels driven) Power Output - 8 ohms (Bridged) 325 Watts Frequency Response 5Hz – 50kHz, bandwidth limited Total Harmonic Distortion 0.15% (1kHz, 8 ohms) 0.
SONAMP 2-100 & 12-50 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL SPECIFICATIONS SONAMP 12-50 Number of Channels 12 (6 stereo pairs) Power Output - 8 ohms (Stereo) 50 Watts RMS per channel (all channels driven) Power Output - 4 ohms (Stereo) 50 Watts RMS per channel (all channels driven) Power Output - 8 ohms (Bridged) 100 Watts Frequency Response 5Hz – 50kHz, bandwidth limited Total Harmonic Distortion 0.05% (1kHz, 8 ohms) 0.
SONAMP 2-100 & 12-50 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL LIMITED TWO (2) YEAR WARRANTY Sonance warrants to the first end-user purchaser that this Sonance-brand product (Sonamp 2-100 Amplifier or Sonamp 12-50 Amplifier), when purchased from an authorized Sonance Dealer/Distributor, will be free from defective workmanship and materials for the period stated below.