User Manual

16
Auto On Setting Sleep Mode Options Time To Music Ethernet
Audio O Alwayson Alwayson
Audio 15Min 6-8seconds Alwayson
Audio 3Hrs 6-8seconds Alwayson
Auto On Setting Sleep Mode Options Time To Music Ethernet
PowerButton O Alwayson Alwayson
PowerButton 15Min 2-3seconds Alwayson
PowerButton 3Hrs 2-3seconds Alwayson
APPENDIX B
DSP 2-750 MKII Amplier - Auto On/Sleep Mode Details
Auto On Setting Sleep Mode Options Time To Music Ethernet
AudioGreen None 6-8seconds Turnsoafter15minswithoutaudio
Auto On Setting Sleep Mode Options Time To Music Ethernet
Voltage None 6-8seconds Alwayson
Auto On Setting Sleep Mode Options Time To Music Ethernet
VoltageGreen None 6-8seconds Turnsoafter15minswithoutvoltage
Dim White Power Button Amplierispluggedinandinstandbymode.
BrightWhitePowerButton  Amplierisactive.
Power Button Blinking The amp is in ID Amp Mode (see page 9).
Green LED Signal is present (>1.0mv) on channel.
Blinking Green Signal is going above and below the active level or between songs.
Blinking Red The channel is being over driven.
Solid Red The amp is in protection mode (see page 6).
Power Button Blinking Light Amp temperature exceeds the design maximum.
+LED’sBlinkingRed
Step1    Turnampliero.
Step 2 With light pressure adjust 1L Volume Control full counter clockwise.
Step 3 With light pressure adjust 1R Volume Control full clockwise.
Step4    Poweronamplier(waitforPowerButtontoshowaseriesofashes).
Step5    Turnampliero.
Step 6 Set the 1L Volume Control full clockwise or at desired volume level.
Step7    Poweronamplier.
LED Indicator
Explanation
DHCP Reset / Factory Reset
DHCP Resent / Factory Reset Steps from Front of Amplier
APPENDIX A
DHCP Reset / Factory Reset DHCP Resent / Factory Reset Steps within SonARC
Step 1 InaURLaddresswindowentertheampliersIPaddresswiththeextension/Update.htm
       (ex.192.168.1.100/Update.htm)
Step 2 Ontheupdatepage,locatetheredresetbutton.Usethisbuttontocompletelyresettheamplier.
Step 3
ReturntotheHomePagetosetuptheamplier.Note:EQpresetswillnotbedeleted.