User Manual

15
LED Indicator Explanation
Dim White Power Button Amplifier is plugged in and in standby mode.
Bright White Power Button Amplifier is active.
Power Switch Blinking The amp is in ID Amp Mode (see page 9).
Green LED Signal is present (>2.5mv) on channel.
Blinking Green Signal is going above and below the active level or between songs.
Blinking Red The channel is being overdriven.
Solid Red The amp is in protection mode (see page 6).
Power Switch Blinking Light
+LED’s Blinking Red
Amp temperature exceeds the design maximum.
DHCP Reset Step DHCP Reset Steps
Step 1 Turn amplifier off.
Step 2 With light pressure adjust 1L Volume Control full counter clockwise.
Step 3 With light pressure adjust 1R Volume Control full clockwise.
Step 4 Power on amplifier (wait for Power Button to show a series of flashes).
Step 5 Turn amplifier off.
Step 6 Set the 1L Volume Control full clockwise or at desired volume level.
Step 7 Power on amplifier.
Amplifier Factory Reset Steps
In a URL address window enter the amplifiers IP address
with the extension /Update.htm
On the update page, locate the red reset button.
Use this button to completely reset the amplifier.
Return to the Home Page to set up the amplifier.
Note: EQ presets will not be deleted.
Amplifier Factory Reset
Step 1
Step 2
Step 3
APPENDIX A