Installation Guide

SST / SUR Setup and Connection
Use as a Surround (SUR)
Connect the + and - wires from your amplifier or receiver to either
pair of terminals on the VP SST/SUR speaker. Remove the red sticker
and set the switch to SUR.
Use as a Single Stereo Technology (SST)
Connect the + and - wires from the left channel to one pair of
terminals and the + and - wires from the right channel to the other
pair of terminals .
The switch is preset in the SST mode and should not be changed
(figure 11).
NOTE: WHEN THE SWITCH IS PLACED IN THE SUR MODE THE
TWO PAIRS OF BINDING POSTS ARE CONNECTED! DAMAGE CAN
OCCUR TO YOUR AMPLIFIER IF YOU CONNECT TWO DIFFERENT
AMPLIFIER CHANNELS TO THE SPEAKER WITH THE SWITCH SET IN
SUR MODE.
Figure 11
VISUAL PERFORMANCE
®
RECTANGLE SPEAKERS
4