User manual

PQM-702, PQM-703 Operating Manual
112
8 Other Information
8.1 Cleaning and maintenance
The casing of the analyzer may be cleaned with a soft, damp cloth using all-purpose detergents.
Do not use any solvents or cleaning agents which might scratch the casing (powders, pastes, etc.).
Cables should be cleaned with water and detergents, and then dried.
The analyzer electronic system does not require maintenance.
8.2 Storage
In the case of storage of the device, the following recommendations must be observed:
 Disconnect all the test leads from the meter.
 Clean the meter and all its accessories thoroughly.
 In order to prevent a total discharge of the accumulators in the case of a prolonged storage,
charge them from time to time.
8.3 Dismantling and utilization
Worn-out electric and electronic equipment should be gathered selectively, i.e. it must not be
placed with waste of another kind.
Worn-out electronic equipment should be sent to a collection point in accordance with the law
of waste electrical and electronic equipment.
Before the equipment is sent to a collection point, do not dismantle any elements.
Observe local regulations concerning disposal of packages, waste batteries and accumulators.
8.4 Manufacturer
The manufacturer of the device and provider of guarantee and post-guarantee services:
SONEL SA
ul. Wokulskiego 11
58-100 Świdnica
Poland
Front desk: [phone]
Fax: [phone]
e-mail: [e-mail]
internet: www.sonel.pl
Note
Use only the maintenance methods specified by the manufacturer in this
manual.
Note
Service repairs must be performed only by the manufacturer.