User manual

PQM-702, PQM-703 Operating Manual
20
Screen 9 (Fig. 13) allows user to quickly view the main configuration parameters of the measure-
ment point:
 mains system,
 clamps type,
 nominal values of: voltage, current and frequency.
Fig. 13. Screen 9 with information on the measurement point settings.
2.5 "Sonel Analysis 2" software
"Sonel Analysis 2" is an application required to work power analyzers of PQM series. It enables
the user to:
 configure the analyzer,
 read data from the device,
 real-time preview of the mains,
 delete data in the analyzer,
 present data in the tabular form,
 present data in the form of graphs,
 analyzing data for compliance with EN 50160 standard (reports), system commands and other
user-defined reference conditions,
 independent operation of multiple devices,
 upgrade the software and the device firmware to newer versions.
Detailed manual for "Sonel Analysis 2" is available in a separate document (also downloadable
from the manufacturer's website www.sonel.pl).
2.6 PC connection and data transmission
The analyzer provides three ways of communication with a PC. They are as follows:
 wired communication via USB,
 radio communication using OR-1 receiver,
 built-in wireless connectivity via GSM modem.
Connection to a computer (PC mode), ensures:
 Transmission of data stored in the recorder memory:
o it is possible to read the data of all measurement points regardless of the recording state,
 Viewing mains parameters on PC:
o instantaneous values of: current, voltage, power and energy, total values for the entire sys-
tem,
o harmonics, interharmonics, harmonic power values, THD, TID,
o unbalance,