User manual

2 Operation of the analyzer

Fig. 25. Entering GSM settings in the analyzer database

If you remove the SIM card from the slot, the analyzer will display error message "No SIM card".

This message is repeated during next activations of the analyzer. Removing the SIM card while the

analyzer is in operating mode, it is not recommended, as it prevents correct analyzer logging off

from the GSM network.

2.11.3 Checking GSM connection

If status screen <8/9> shows the status of GSM modem as "Ready, <connection type>", it

means that a connection from a remote PC may be performed via Internet. The user may perform

a test connection to verify the connectivity with "Sonel Analysis 2”:

 In the program settings, check whether the search of the analyzers via GSM network is

enabled: select Options Configuration Media settings Active media. Check

TCP/IP over GSM box.

 The analyzer that is chosen for the connection must be entered into the Analyzer database

(when the modem was configured as described in sec. 2.11.2 this will be ensured).

 Disconnect any connection to the analyzer (USB or OR-1).

 Perform a search for the analyzer, selecting any available method (e.g., by clicking Live

mode). The search list should show the analyzer with note "(GSM)". Select the analyzer

and click OK.

 After a while, the screen should display the desired window (e.g. Live Mode) and the status

bar should display "Connected" message. Also the analyzer screen will display "Connected

to PC (GSM)" message. The connection attempt was successful.

Note

After any change in GSM settings, its automatic restart is initiated.