User manual

2 Operation of the analyzer
41
the analyzer and on screen <8/9> check the status of GSM (whether the connection is made
properly).
The card may be also unlocked by inserting it into any mobile phone and entering PUK code
and a new PIN code.
Note: several attempts to enter incorrect PUK code will result in irreversible blocking
of the SIM card!
Problem: The analyzer reports GSM errors: "Network Error", "SMS Error", "No network" or other.
Possible Cause: One of GSM network errors occurred. It may be caused by entering wrong phone
number for SMS notifications or temporary loss of network coverage.
Solution: In case of SMS error, check the correctness of the entered phone number. In other cases,
do not take additional steps. The analyzer will try to repeat the operation after some time
(e.g. 5 minutes).
2.12 Notification of analyzer changed location
The analyzer, which operates a GSM modem and is within a range of GPS, may notify the user
about its movements. To use this feature the user must activate "Anti-theft function" from the PC
program and fill the appropriate list of emergency phone numbers for sending SMS messages with
appropriate information. In this mode, the analyzer saves the position where it was acquired for the
first time after turning on the recording and then sends an SMS message to the defined phone
number(s), if the analyzer changes its location by more than 100 m. SMS message contains the
actual coordinates of the analyzer. Also "Sonel Analysis 2" enables user to connect user to the
analyzer via GSM to check the analyzer current location on the status screen (even when the ana-
lyzer is turned off - see below). When the analyzer remains for a long time at a distance greater
than 100 m from its start position, then it sends SMS messages every 10 minutes detailing the
current position of the analyzer (max. 10 SMS messages).
In adverse conditions for GPS reception (weak signal, signal reflections) the analyzer may send
erroneous message on the location. The user is also notified of the loss/return of GPS signal by
additional SMS messages.
After activating the anti-theft function, the analyzer behaves differently during switch-off mode:
GSM modem and a GPS receiver are continuously active. This is also the cause of faster discharg-
ing of the battery in the absence of power supply from mains, similarly as during normal operation
with the battery power supply. After discharging, the analyzer will switch-off totally and sending SMS
messages will be impossible.
2.13 Key lock
Using the PC program, the user may select an option of locking the keypad after starting the
process of recording. This solution is designed to protect the analyzer against unauthorized stop-
ping of the recording process. To unlock the buttons, the user must enter a code consisting of 3
digits:
 pressing any button will display message "Enter Code", and three dashes "- - -"
Note
Anti-theft feature requires the following arrangements for proper opera-
tion:
 active GSM modem with properly configured SIM card,
 at least one emergency telephone established to send SMS's.
While activating the anti-theft function, both of the above features must be
checked.