Quick Installation Guide

ManualsBrandsSonic Innovations ManualsElectronicsHearing Aid Module

Table Of Contents

Oticon Radio Model - Regulatory Label Information for USA & Canada
- This device complies with Part 15 of the FCC Rules and with RSS-210 and RSS-247 of Industry Canada.
  - Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:

Sonic Radio Model - Quick Installation Guide Radio Model

Name: Sonic BTE SP

On the bottom side of the main PCB of the Sonic BTE SP radio model the connector for the speaker unit assembly (where the wire antenna for the

Bluetooth radio is an integrated part), the programming connector, EEPROM memory and coil antenna for the 3.84 MHz radio can be seen:

The most important parts inside the Engine module are a Digital-Signal-Processor (DSP), a radio Front-End (FE) chip for the 3.84 MHz radio part and an RF

chip for the Bluetooth radio part – all mounted on a small rigid PCB again mounted on the main flex PCB. The Sonic BTE SP radio model also includes all

voltage regulators and buffered data programming inputs on board. The DSP is the main processor controlling the functionality of both radios in the Sonic BTE

SP radio model.

Sonic BTE SP Radio Model – Main PCB – Bottom side