Operation Manual

Quadpacer

The Quadpacer is an interval timer that has a short beep and pause to

remind you to brush the 4 sections of your mouth. Depending on the

brushing mode or brushing routine you have selected, the Quadpacer

beeps at different intervals during the brushing cycle. See the ‘Brushing

instructions’ and ‘Personalising your brushing experience’ sections.

The Quadpacer on this model has been activated. To deactivate or

reactivate the Quadpacer:

1 Place the handle with a brush head attached on the plugged-in

charger or sanitiser

2 To deactivate the Quadpacer: press and hold the Personalised

Brushing button for 5 seconds. You hear 1 beep to indicate that the

Quadpacer has been deactivated.

To reactivate the Quadpacer: press and hold the Personalised

Brushing button for 5 seconds until you hear 2 beeps. This indicates

that the Quadpacer is active again.

Note: The Quadpacer cannot be deactivated on the pre-programmed Go Care

and Max Care brushing routines.

Cord wrap on deluxe charger (speciﬁ c types only)

If your model includes the deluxe charger cover and base, the travel

charger is pre-installed inside the cover. If you want to shorten the mains

cord, you can store excess cord in the cord-wrap feature built into the

charger base.

1 To separate the charger cover from the charger base, press the two

grey snap bars on the charger base and pull the white charger cover

upwards.

2 Wrap excess cord around the grey charger base as shown in the

picture. Be sure to wrap the cord on the inside of the two snap

levers.

3 When you have stored the excess cord, guide the cord through the

small groove in the rear of the grey charger base.

4 Reattach the charger cover by pressing it down over the charger

base until it snaps into place.

Tip: For extra convenience during travel, you can remove the travel charger and

use it without the charger cover and charger base.

ENGLISH 9