USER MANUAL FOR SONICLEAN DIGITAL BENCHTOP ULTRASONIC CLEANERS MODELS: 80TD, 120TD, 160TD/HD, 250TD/HD, 500TD/HD, 800TD/HD, 1000TD/HD, 2000TD/HD, 3000TD/HD & 3800TD/HD For further information visit Soniclean Helpdesk: http://helpdesk.soniclean.com.
CONTENTS PRECAUTIONS & SAFETY INSTRUCTIONS page 1 CONTROL PANEL page 2 OPERATING YOUR UNIT page 2 PREPARATION page 2 BASIC SETTINGS page 2 DEGAS page 2-3 FOR HEATER MODEL page 3 ULTRASONIC PERFORMANCE page 3 ADVANCED SETTINGS page 4 REFERENCE TABLE page 4 -6 TROUBLE-SHOOTING page 7 CUSTOMER WARRANTY RECORDS page 8 MANUFACTURER/SUPPLIER WARRANTY RECORDS page 9 CONTACT INFORMATION page 10 Issue date: 190913-1
PRECAUTION & SAFETY INSTRUCTIONS. PRECAUTIONS Membrane keypad The touch sensitive keypad is waterproof with easy wipe down surface. Do not operate keys with sharp objects. If water enters under the fascia, send the unit to an authorized Soniclean service center for repair. Aerosols Do not switch on ultrasonic without the lid to prevent possible dangerous aerosols from the liquid. Keep lid and tank edge dry to reduce aerosol.
DO: operate in normal room temperatures around 25C. use adequately and correctly earthed mains electricity supply with correct voltage to your ultrasonic cleaner. Check with qualified electrician if in doubt. ● fill at least 2/3 full or ¾ full on heated models. ● use a basket/tray/rack to prevent contact between objects and the tank.
10 Adjust down Power Level if required. Default is 100% maximum power. These optimized basic settings will be retained so long as the unit is powered on. 11 Leave unit to complete the operation or press Stop to cancel. 12 Operate with the lid on where possible. 13 After cleaning, rinse parts using clean running water. FOR HEATER MODELS 14 Follow steps 1-6 before switching on heater. 15 Press Heater On to change heater temperature using More or Less keys to increase or decrease temperatures.
Soniclean's Ultrasonic Performance Meter Soniclean's detergents ADVANCED SETTINGS 24 Check to ensure the features and functionalities correspond to software version number. Press Status key and scroll through to display eg software version. 25 Press Status key repeatedly to scroll through various settings on the unit. The Status key displays information such as tank temperature, clean time, degas time, power level and software version. 26 The Setup keys have other functionalities.
XXOC Water temperature updated every 5 sec. XX 100.P 80.P 60.P 100% Power levels. Degas dGAS MM.SS Degas displays every 5 sec. Cleaning time. The display is in MM.SS where MM in minutes and SS in seconds. Degas cycle is: H,3-M,1-L,1-OFF,1 SEC Power Level 100.P 80.P 60.P Press repeatedly to scroll through and select Power levels when unit is in standby or operating Heater On Off H.On Heater On. Key valid when heater is enabled. The LED will blink when the set temperature is reached.
Heater Temperature: 50 OC. Duty cycle disabled. Lid disabled Beep enabled U.SEt U.On User setup. Use More or Less key to toggle U.On Lid L.On L.OFF Lid.o PAUS Lid interlock option Use More to enable lid interlock Use Less to disable lid interlock When lid interlock is enabled and the lid is open. When the lid interlock is enabled and the lid is opened the ultrasonics will pause When lid is replaced press Start to continue. P.dc Power set to enable or disable Duty cycle.
TROUBLE-SHOOTING GUIDE Foil test Poor 1. Check power level set – should be set to High 2. Does the unit have recommended amount of detergent? Is the detergent approved by SONICLEAN? 3. Has the unit degassed properly? Whilst in the degas mode look for suspended bubbles in water. There should not be any. 4. Is the water too hot? If so remove some (not all) and replace with cold water. Replenish the detergent to bring to the correct concentration. 5. Is the aluminum foil too thick – should be 0.
CUSTOMER WARRANTY RECORDS WARRANTY (Customer Records) For goods purchased in Australia after 1 January 2012: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
MANUFACTURER WARRANTY RECORDS WARRANTY (Manufacturer Records) Return to Manufacturer For goods purchased in Australia after 1 January 2012: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage.
CONTACT INFORMATION SONICLEAN PTY LTD ACN 057 730 917 ABN 89 057 730 917 38 Anderson Street, Thebarton, South Australia, AUSTRALIA PO Box 398 Stepney, 5069, South Australia, Australia Phone: +61 8 8234 8398 Fax: +61 8 8234 8391 Web: www.soniclean.com.au Email: sales@soniclean.com.
