User Manual

CAUTION

• Never allow liquid to spill into the converter. Do not use the cup horn without a

splash shield

• Do not allow a microtip or extender to vibrate in air for more than 10 seconds.

When working with a microtip never allow the AMPLITUDE control to be set

above the microtip limit 40%. Ignoring these instructions will cause the microtip

to fracture.

• Do not allow the vibrating microtip to contact anything but the sample.

• When working with low surface tension liquids, do not use a probe with a

replaceable tip.

• Never energize a threaded probe without the replaceable tip, extender, or microtip

attached.

NOTE

Refer to Section IV, for general operating suggestions and ultrasonic processing

techniques.

1. Set ON/OFF power switch to ON. The switch will illuminate and the screen will

display the power rating of the Ultrasonic Processor, cautionary notices, and the

following control parameters.

TIME __:__:__ TEMP __ __°C

PULSE__:__:__ AMPL __ __%

Go To Top Of Document