User Manual
Table Of Contents
- SonicWALL TZ 150 Wireless Security Appliance Getting Started Guide
- Before You Begin
- SonicWALL TZ 150 Wireless Configuration
- Collect Required Information
- Applying Power to the SonicWALL TZ 150 Wireless
- Connecting the SonicWALL TZ 150 Wireless
- Accessing the Management Interface
- Using the SonicWALL Setup Wizard
- Registering Your SonicWALL TZ 150 Wireless
- Activating SonicWALL Security Services
- Connecting Wireless Clients to the SonicWALL TZ 150 Wireless
- Connecting Computers to Your SonicWALL TZ 150 Wireless
- Configuring DHCP IP Addressing
- Wall Mounting the SonicWALL TZ 150 Wireless
- SonicWALL TZ 150 Wireless Security Appliance Regulatory Statement and Safety Instructions
- Glossary of Networking Terms
- Notes
- Notes
Page 42
Notes
FCC Statement
This equipment has been tested and found to comply with the limits for a class
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, amy cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does not
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.
To assure continued compliance, any changed or modifications not expressly
approved by the party responsible for compliance could void the user's authority to
operate this equipment.
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth set forth
an uncontrolled environment. This equipment should be installed and operated with
a minimum distance 20 cm between the radiator and your body.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that
may cause undesired operation.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
The antennas used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating
in conjunction with any other antenna or transmitter.
This equipment marketed in USA is restricted by firmware to only operate on 2.4G
channel 1-11.