User Manual
Table Of Contents
- SonicWALL TZ 150 Wireless Security Appliance Getting Started Guide
- Before You Begin
- SonicWALL TZ 150 Wireless Configuration
- Collect Required Information
- Applying Power to the SonicWALL TZ 150 Wireless
- Connecting the SonicWALL TZ 150 Wireless
- Accessing the Management Interface
- Using the SonicWALL Setup Wizard
- Registering Your SonicWALL TZ 150 Wireless
- Activating SonicWALL Security Services
- Connecting Wireless Clients to the SonicWALL TZ 150 Wireless
- Connecting Computers to Your SonicWALL TZ 150 Wireless
- Configuring DHCP IP Addressing
- Wall Mounting the SonicWALL TZ 150 Wireless
- SonicWALL TZ 150 Wireless Security Appliance Regulatory Statement and Safety Instructions
- Glossary of Networking Terms
- Notes
- Notes
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following
test methods have been applied in order to prove presumption of conformity with the essential requirements
of the R&TTE Directive 1999/5/EC:
- EN 60950-1: 2001
Safety of Information Technology Equipment
- EN 50392: 2004
Generic standard to demonstrate the compliance of electronic and electrical apparatus with the basic
restrictions related to human exposure to electromagnetic fields (0 Hz - 300 GHz)
- EN 300 328 V1.7.1 (2006-10)
Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband transmission systems;
Data transmission equipment operating in the 2,4 GHz ISM band and using wide band modulation
techniques; Harmonized EN covering essential requirements under article 3.2 of the R&TTE Directive
- EN 301 489-17 V1.2.1 (2002-08) and EN 301 489-1 V1.5.1 (2004-11)
Electromagnetic compatibility and Radio spectrum Matters (ERM); ElectroMagnetic Compatibility
(EMC) standard for radio equipment and services; Part 17: Specific conditions for 2,4 GHz wideband
transmission systems and 5 GHz high performance RLAN equipment
This device is a 2.4 GHz wideband transmission system (transceiver), intended for use in all EU member states and
EFTA countries, except in France and Italy where restrictive use applies.
In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain
authorization to use the device for setting up outdoor radio links and/or for supplying public access to
telecommunications and/or network services.
This device may not be used for setting up outdoor radio links in France and in some areas the RF output
power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5 MHz. For detailed
information the end-user should contact the national spectrum authority in France.