Manual

12
CM-CU1 Commentator Unit User Handbook
CONFIGURATION OPTIONS
CONFIGURATION OPTIONS
5
TALKBACK C button:
No associated option on this page. This button illuminates amber to indicate button
brightness level.
TALKBACK D button:
No associated option on this page. This button illuminates green to indicate button
brightness level.
Config Page 7 - Save/Load Configurations & Firmware Version
The last page allows you to save the current option settings to either of two available
backup sets that are unaffected by subsequent changes to the option settings. The backup
sets can then be reloaded when required. The load/save functions only work whilst in
Config Page 7.
Version Firmware
config Page 7 shows the current firmware version by flashing the Limit LED in a recurring
sequence i.e. 1 flash for version 1, 2 flashes for version 2, etc.
To Save The Current Option Settings to Backup Set 1
Press and hold the ON AIR and TALKBACK B buttons for 2 seconds. These buttons will then
illuminate red to verify that the options have been saved to backup set 1.
To Save The Current Option Settings to Backup Set 2
Press and hold the ON AIR and TALKBACK D buttons for 2 seconds. These buttons will then
illuminate red to verify that the options have been saved to backup set 2.
To Load Backup Set 1 & Overwrite The Current Option Settings
Press and hold the ON AIR and TALKBACK A buttons for 2 seconds. These buttons will then
illuminate red to verify that backup set 1 has been loaded.
To Load Backup Set 2 & Overwrite The Current Option Settings
Press and hold the ON AIR and TALKBACK C buttons for 2 seconds. These buttons will then
illuminate red to verify that backup set 2 has been loaded.
To Exit Setup Mode
Press and hold the TALKBACK A and TALKBACK B buttons for 3 seconds. When the power
indicator stops flashing, the On Air buttons can be released and the unit enters normal
operating mode.
In addition to being able to load and save options, it is also possible to return the setup
options to their factory default settings. Please note: all changes made to the options
settings will be lost. Loading of the factory defaults does not affect the options stored in
the backup sets.
To Return The Current Option Settings to Factory Defaults
Apply power to the unit whilst keeping TALKBACK C and TALKBACK D buttons pressed for
5 seconds. These buttons then illuminate red to verify that the default options have been
loaded. After the default options have been restored, the unit returns to normal operating
mode.