Handbook
Table Of Contents
- Warranty
- Safety Information
- Installation Information
- Confidence Monitors Introduction
- RM-CA2 Confidence Monitor, 2 LED Meters &
- 2 Analogue Stereo Inputs
- RM-CAD8 Confidence Monitor, 2 LED Meters, 2 Analogue &
- 6 Digital Stereo Inputs
- Technical Specification RM-CA2 & RM-CAD8
- Fig A: Packing List
- Fig B: Power Connections
- Fig C: Mains Lead Table
- Fig 1-1: RM-CA2 Confidence Monitor Front Panel
- 
- Fig 1-3: Confidence Monitor Block Diagram
- Fig 1-4: RM-CA2 Front Panel Controls
- Fig 1-5: RM-CAD8 Front Panel Controls
- Fig 1-6: RM-CA2 Source Selector Button Fig 1-7: RM-CAD8 Source Selector Button
- Fig 1-8: RM-CA2 & RM-CAD8 Meters & Phase Error LED
- Fig 1-11: RM-CA2 & RM-CAD8 Meters & Phase Error LED
- Fig 1-12: Confidence Monitor RM-CA2 Rear
- Fig 1-13: Confidence Monitor RM-CAD8 Rear
- Fig 1-14: DIPSwitch Settings
12
Condence Monitors User Handbook
4
TECHNICAL SPECIFICATION
RM-CA2 & RM-CAD8
TECHNICAL SPECIFICATION RM-CA2 & RM-CAD8
Amplier/Loudspeakers
Conguration: Three-way with stereo mid/
high-frequency drivers & mono
low-frequency driver
Power Output: 2 x 7W (HF) + 15W (LF) with protective limiter
Crossover: 250Hz (24dB/octave, Linkwitz-Riley)
Distortion (HF Outputs): < 0.1% (1kHz, 3W output)
Distortion (LF Output): < 0.1% (100Hz, 6W output)
Noise: More than 102dB below full output
Volume: Mute to full volume via front panel rotary
control (mute, -52 to +18dB)
Balance Trim: ±6dB via front panel rotary control.
Peak Acoustic Level: 96dB SPL @ 2ft
Level & Phase Metering
Number: 2 x 8-segment LED bargraphs
Line-Up Level: 0dB on scale can be set to 0dB or -10dB for analogue
input 2 via rear panel DIP switch
Phase Meter: Single LED indication showing error
Connectors
Audio Inputs 4 x XLR 3-pin female balanced
(RM-CA2): 2 x RCA female phono unbalanced
Audio Inputs 4 x XLR 3-pin female analogue
(RM-CAD8): 2 x RCA phono analogue
4 x XLR 3-pin female AES/EBU digital
1 x RCA phono female S/PDIF digital
1 x optical TOSLink digital
Audio Outputs: 2 x XLR 3-pin male (balanced, may be unbalanced)
Headphones: 1/4” (6.35mm) A-gauge 3-pole stereo jack socket