Use Manual

Introduction

Please take the time to read all of the information in this manual. Familiarity

with operation and installation procedures will help you obtain the best possible

performance from your new Bluetooth PTT Car Kit for XP6

& XP7

. This car kit is

intended to be installed by a professional installer

WARNING: Changes or modifications made to this equipment not expressly approved by Sonim

Technologies, Inc. for compliance could void the user’s authority to operate the equipment.

FCC Statement

• This device complies with part 15 of the FCC rules (FCC ID: WYPVK01011AA). Operation is

subject to the following two conditions:

• This device may not cause harmful interference.

• This device must accept any interference received, including interference that may cause

undesired operation.

• This device has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses, and can radiate radio frequency energy, and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation

if this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution

Any changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

The antenna(s) used for this transmitter must not be co-located or operating in conjunction

with any other antenna or transmitter.

CE Statement

This device complies with the R&TTE directive (1999/5/EC), the EMC Directive (2004/108/

EC), and the Low Voltage Directive (2006/95/EC) issued by the Commision of the European

Community.

IC Statement

Operation is subject to the following two conditions:

1. This device does not cause harmful interference.

2. This device must accept any interference, including interference that may cause undesired

operation of the device.

CE Mark & NB Identification Number

1 7 9 7

This device complies with RSS-310 of Industry Canada (IC:8090A-VK01011AA).