Extra Information

XPSI 4.1, Release Note
Confidential - Partner Only Doc No.
2
3. Questions on Enduro
3.1 PC Tools indicates that no USB device is connected.
If the Device Manager shows the phone as being installed using a Generic Sonim driver, but
PC Tools indicates that no USB device is connected, then please follow the below steps:-
a) connect your XP3 to PC through USB cable
b) Go to start > settings > control panel > Phones and Modem > click on modem tab and check the
XPx modem and COM port details.
c) Launch the Mobile PC tool and select interface setup. Please select it as USB and also select
the proper COM port and click on OK.
d) After doing this kindly exit and relaunch the tool.
Note: Please follow the PC tool installation guide for more details.
3.2 At the selection by the cable, the port disappears.
a) Connect your XP3 to PC through USB cable.
b) Go to start > settings > control panel > Phones and Modem > click on modem tab and check the XPx
modem and COM port details.
c) Launch the Mobile PC tool and select interface setup. Please select it as USB and also select the
proper COM port and click on OK.
d) After doing this kindly exit and relaunch the tool.
3.3 How to check the memory status, how to sync contacts and
how many contacts can be stored in enduro ?.
Support : After deleting the contacts from XP3 phone, please restart the phone and then check the memory
status. To do this go to Menu > phone book > Memory status.