Bell Canada User Guide

46
REGULATORY INFORMATION
xed to US operation channels only.
• Operations in the 5.15-5.25GHz band are
restricted to indoor usage only.
INDUSTRY CANADA STATEMENT (IC:
8090A-PG4032)
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the
following two conditions:
• This device may not cause interference, and
• This device must accept any interference,
including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions
suivantes:
• l’appareil ne doit pas produire de brouillage, et
• l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
• This device complies with RSS-310 of Industry
Canada. Operation is subject to the condition that
this device does not cause harmful interference.
• Cet appareil est conforme à la norme RSS-310
d’Industrie Canada. L’opération est soumise à la
condition que cet appareil ne provoque aucune
interférence nuisible.
• This device and its antenna(s) must not be co-
located or operating in conjunction with any other
antenna or transmitter, except tested built-in radios.
• Cet appareil et son antenne ne doivent pas être
situés ou fonctionner en conjonction avec une autre
antenne ou un autre émetteur, exception faites des
radios intégrées qui ont été testées.
• The Country Code Selection feature is disabled for
products marketed in the US/ Canada.
• La fonction de sélection de l’indicatif du pays est
désactivée pour les produits commercialisés aux
États-Unis et au Canada.
RADIATION EXPOSURE STATEMENT
The product comply with the Canada portable RF
exposure limit set forth for an uncontrolled environment
and are safe for intended operation as described inthis
manual. The further RF exposure reduction can be
achieved if the product can be kept
as far as possible
from the user body or set the device to lower output
power if such function is available.
ADDITIONAL STATEMENT FOR PHONES
This device has been tested for compliance with IC
SAR values at a typical operating near the body. To
ensure that RF exposure levels below the levels tested,
use accessories with this equipment to maintain a
minimum separation distance of 1.0 cm between the
body ofthe user and the device. These
accessories
should not contain metallic
components. It is possible that the accessories used
close to the body that do not meet these requirements
are not consistent with the SAR limits and it is advisable
to avoid using them.
CAUTION
1. The device for operation in theband 5150-5250MHz
is only for indooruse to reduce the potential forharmful
interference to co-channel mobile satellitesystems;
2.The maximum antenna gainpermitted for devicesin
the bands 5250-5350 MHz and 5470-5725MHzshall
comply with the e.i.r.p. limit;and 3. The maximum
antenna gainpermitted for devicesin the band
5725-5825 MHz shall comply with thee.i.r.p. limits
specified for point-to-pointand nonpoint-to-point
operation asappropriate.
4.The worst-case tilt angle(s)necessary to remain
Federal Communication Commission Interference
(FCC) Statement62compliant with the e.i.r.p. elevation
maskrequirement set forth in Section6.2.2(3) shall
beclearly indicated.
5. Users should also be advised that high-powerradars
are allocated asprimary users (i.e. priorityusers) of the
bands 5250-5350 MHz and5650-5850MHz and that
these radarscould cause interferenceand/ordamage to
LE-LAN devices.