Safety Precautions Table OF CONTentS TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR MOISTURE. TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE CABINET. REFER SERVICING TO QUALIFIED PERSONNEL ONLY. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquid, such as vases, shall be placed on the apparatus.
LOCATION OF CONTROLS remote control Unit Using the Remote Control Correctly 1. CD Door 2. Left Speaker 3. STANDBY indicator 4. 5. 6. 7. STANDBY/ON button Remote sensor PLAY/PAUSE button • Point the remote control at the REMOTE SENSOR located on the unit. • When there is a strong ambient light source, the performance of the infrared REMOTE SENSOR may be degraded, causing unreliable operation. • The recommended effective distance for remote operation is about 6 meters (19 feet).
Power sources LISTENING TO THE RADIO CAUTIONS: • Before use, ensure the rated voltage of the adapter matches your local voltage. • The included AC adapter is for use with this unit only. Do not use it with other equipment. • If you are not going to use the unit for a long time, disconnect the AC adapter from the wall outlet completely. • Whenever the AC adapter is plugged into a wall outlet, electricity is running through the unit, even when the power switch is turned off. 1.
repeat playback LISTENING TO YOUR iPod Repeat Current Track • Press the /MEM. UP button on the remote control until “ repeatedly. ” blinks on the display. The current track will be played Repeat the Entire CD • Press the /MEM. UP button on the remote control until “ repeatedly. ” stops blinking and remains on. All tracks will be played Cancel Playback Mode • Press the /MEM. UP button on the remote control until “ ” disappears.
SLEEP TIMER setting PRESET EQ This system supports a variety of equalizers and sound effects. During playback, press the PRESET EQ button to select a desired music mode. Each time the PRESET EQ button is pressed, the music mode will be changed to the next one as follows: -> (ROCK) -> -> (CLASSIC) CD mode 1. During playback, press the DISPLAY button repeatedly to shuffle between the CD playback mode and the current time. 2.
troubleshooting guide Problems Solutions CD System does not turn on • Make sure AC adapter is secure in the outlet, and outlet has power. • Make sure you’ve selected CD mode. Disc in place but unit won’t play • • • • Disc skips • Make sure the unit is on a secure spot. Vibration or jarring can cause the disc to skip. Make sure disc label is facing out. Make sure disc is clean. Pause mode is activated. Disc may be damaged or dirty; check disc.
Fron C o v et r
