Manual

21
Delay
The Delay effect produces a stereo echo of the signal.
• Mix: Adjust the "dry/wet" mix (the blend between the signal without
delay and the delay itself) with this knob.
• Feedback: Adjust how much of the effect signal is routed back into the
effect again.
• LPF: Set the low-pass filter frequency with this knob.
• HPF: Set the high-pass filter frequency with this knob.
• Sync: You can synchronize the delay effect with the clock of your host
software by turning this switch on.
o When Sync is off, you can adjust the rate of the delay in the left
and right channels with the Time knobs.
o When Sync is on, you can adjust the delay's time division Beat
knobs. The numbers indicate note values (e.g., 1/2 indicates a
half-note), and a "t" next to the value indicates it is triplet-based.
Reverb
The reverb effect simulates the nuanced reverberation due to the space of a
particular room.
• Dry: Adjust the level of the "dry" signal (without reverb applied) with
this knob.
• Wet: Adjust the level of the "wet" signal (only the signal with reverb
applied) with this knob.
• Room Size: Adjust the simulated room size with this knob.
• Damping: Adjust the absorption of higher frequencies (over the time of
reverberation) with this knob.
• Width: Adjust the width of the stereo image generated by the reverb.