Installation & Assembly

2 of 2

September 4, 2019

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Offset Series- 24" Racetrack Surface Mount, 36" Racetrack Surface Mount,

24" Rectangle Surface Mount, 36" Rectangle Surface Mount

Important

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

1. Shut off power to the outlet box (A).

2. Attach the Ceiling Plate (B) to the outlet box (A), secure with outlet box screws (C).

3. Connect safety cables (E) to ceiling plate (B) and xture (F) by screwing the nials onto the threaded studs (Fig. 1).

4. Make appropriate electrical connections using wire nuts:

a. Connect the LED driver’s (D) live wire (black) to the live outlet box wire.

b. Connect the LED driver’s (D) neutral wire (white) to the neutral outlet box wire.

c. Connect the xture’s ground wire (green or uncoated) to the ground outlet box wire. If no ground is present in

outlet box, connect xture’s ground wire to the ceiling plate (B) using the green screw (included).

d. Connect low voltage output wires from LED driver to wires from light xture: red to red and black to black.

e. Carefully place connections in outlet box (A).

5. Install xture (F) to ceiling plate (B) by aligning slots (G) on xture into screws (H) of ceiling plate and sliding into

place. Tighten screws when fully installed.

6. Restore power to the xture.

Note

• This xture is dimmable with Electronic Low Voltage (Trailing-Edge), Incandescent (Leading-Edge) type

dimmers and 0-10V type dimmers.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.

2731, 2733, 2735, 2737

27312735

2733

2737

Fig. 1