Installation Sheet

Important: Always disconnect the power before installing or replacing bulb and before cleaning or other maintenance.

Assembly Instructions for item : 2212, 2213, 2215

Wands Series - 1-Light LED Pendant,

3-Light LED Round Pendant, 5-Light LED Round Pendant

This light should be installed by a licensed electrician

LAMP INSTALLATION AND ASSEMBLY

1. Shut off power to the outlet box. (ﬁg. A)

2. Determine the height at which the ﬁxture is to be hung. Use the screwdriver to loosen

the set screw. (ﬁg. B) Adjust the cords to the desired length. Tighten the set screw to set.

3. Reserve extra cord in the canopy, and adjust the cord lock so they are 12" from the

canopy to prevent slippage.

4. Make appropriate electrical connections using wire nuts:

a. Connect the LED driver’s live wire (brown/black) to the live outlet box wire.

b. Connect the LED driver’s neutral wire (blue/white) to the neutral outlet box wire.

c. Connect ﬁxture’s ground wire (green or uncoated) to the ground outlet

box wire. If no ground is present in outlet box, connect ﬁxture’s ground

wire to the mounting plate using the green screw (included).

d. Carefully place connections in outlet box.

5. Attach mounting plate to the outlet box, secure with outlet box screws.

6. Attach canopy to mounting plate, secure with canopy nuts.

7. Restore power to the ﬁxture.

CARE INSTRUCTIONS

Dusting – Use a clean, dry cloth.

Cleaning – To protect the ﬁnish,

avoid any harsh abrasives or chemicals.

Fingerprints on the acrylic can be removed with rubbing alcohol.

outlet box

canopy

mounting plate

outlet box screw

canopy nut

cord lock

screwdriver

set screw

ﬁg. B

2215: This fixture is dimmable with Electronic Low

Voltage (Trailing-Edge) and Incandescent (Leading-Edge)

type dimmers. For best performance, we recommend

Lutron model CTELV-303P.

2212

2213

2215

LED driver

Note: 2212/2213: These fixtures are not dimmable. Do NOT

use with dimmer switch.

PAGE 1
Assembly Instructions for item : 2212, 2213, 2215 Wands Series - 1-Light LED Pendant, 3-Light LED Round Pendant, 5-Light LED Round Pendant Important: Always disconnect the power before installing or replacing bulb and before cleaning or other maintenance. This light should be installed by a licensed electrician LAMP INSTALLATION AND ASSEMBLY 1. Shut off power to the outlet box. (fig. A) 2. Determine the height at which the fixture is to be hung. Use the screwdriver to loosen the set screw. (fig.