Installation Sheet

Important: Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.
Assembly Instructions for item : 2440, 2441, 2442, 2443
Tubo Slim Series - 12‰ LED Sconce, 12‰ LED Panel Sconce
18‰ LED Sconce, 18‰ LED Panel Sconce
©2014 SONNEMAN - A WAY OF LIGHT
This light should be installed by a licensed electrician
LAMP INSTALLATION AND ASSEMBLY
1. Shut off power to the outlet box. (fig. A)
2. Place fixture on a surface with the LEDs facing up. Place glass on extrusion tube and attach by
inserting top and bottom end caps into the extrusion tube and securing with countersunk screws.
3. Make appropriate electrical connections using wire nuts:
a. Connect the transformer’s live wire (black) to the live outlet box wire.
b. Connect the transformer’s neutral wire (white) to the neutral outlet box wire.
c. Connect fixture’s ground wire (green or uncoated) to the ground outlet
box wire. If no ground is present in outlet box, connect fixture’s ground
wire to the mounting plate using the green screw (included).
d. Carefully place connections and transformer in outlet box.
4. Attach mounting plate to the outlet box, secure with outlet box screws.
5. Install the back plate to the mounting plate by hooking the tab inside the back plate behind the
small tab on the mounting plate, then tipping the back plate against the wall (fig. B). Use Allen
key (included) to tighten the set screw against the large tab to secure.
6. Restore power to the fixture.
CARE INSTRUCTIONS
Dusting – Use a clean, dry cloth.
Cleaning – To protect the finish,
avoid any harsh abrasives or chemicals.
NOTE: This fixture is dimmable with Electronic Low Voltage (Trailing-Edge) type
dimmers only.
CAUTION: Do not touch or apply pressure to the LEDs, or damage will occur.
outlet box
back plate
mounting plate
outlet box screw
set screw
transformer
Fig. B
Allen key
2443
2442
2441
2440
extrusion tube
countersunk screw
top end cap
glass
bottom end cap
option 1
bottom end cap
option 2
back plate tab
small tab
large tab
bottom end cap
option 3