Installation Sheet

Important: Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.
Assembly Instructions for item : 3216, 3217, 3218, 3219
Suspended Glass Slim Series - 18" LED Pendant, 24" LED Pendant
32" LED Pendant, 40" LED Pendant
©2014 SONNEMAN - A WAY OF LIGHT
This light should be installed by a licensed electrician
LAMP INSTALLATION AND ASSEMBLY
1. Shut off power to the outlet box. (fig. A)
2. Determine the height at which the fixture is to be hung. Use the wrench to loosen
the set screw. (fig. B) Adjust the cord to the desired length. Tighten the set screw to set.
3. Adjust the steel cables to match the length of the power cord.
4. Reserve extra cords in the canopy, and adjust the cord locks so they are 12" from the canopy.
5. Onto the front threaded stems, place in order: plastic washer, large front glass, and
another plastic washer. Tighten with spacers.
6. Then onto the front threaded stems, place in order: plastic washer, small front glass,
and another plastic washer. Tighten with finials.
7. Onto the side threaded stems, place in order: plastic washer, side glass, and
another plastic washer. Tighten with decorative rods.
8. Screw the bottom threaded stems to the studs on the bottom surface of splice box.
9. Onto the bottom threaded stems, place in order: plastic washer, bottom glass, and
another plastic washer. Tighten with finials.
10. Attach the mounting plate to the outlet box, secure with outlet box screws.
Use anchors and wood screws for extra support (included)
11. Make appropriate electrical connections using wire nuts:
a. Connect the transformer’s live wire (black) to the live outlet box wire.
b. Connect the transformer’s neutral wire (white) to the neutral outlet box wire.
c. Connect fixture’s ground wire (green or uncoated) to the ground outlet
box wire. If no ground is present in outlet box, connect fixture’s ground
wire to the mounting plate using the green screw (included).
d. Carefully place connections in outlet box.
12. Attach the canopy to the mounting plate, secure with mounting screws.
13. Adjust the cable and cord lengths to level the fixture, making sure
the weight is supported by the steel cables, not the power cords.
14. Restore power to the fixture.
CARE INSTRUCTIONS
Dusting – Use a clean, dry cloth.
Cleaning – To protect the finish,
avoid any harsh abrasives or chemicals.
CAUTION: Do not touch or apply pressure to the LEDs, or damage will occur.
outlet box
canopy
mounting plate
outlet box screw
Note: This fixture is dimmable with
Electronic Low Voltage (Trailing-Edge)
type dimmers only.
mounting screw
plastic washer
side glass
decorative rod
side threaded stem
front threaded stem
plastic washer
spacer
finial
small front glass
large front glass
plastic washer
plastic washer
plastic washer
plastic washer
3216
bottom threaded stem
bottom glass
finial
plastic washer
plastic washer
anchor
wood screw
cord lock
set screw
wrench
stud
Steel cable adjustment instructions:
To shorten the cable - Just push the cable up, cable will be
locked automatically.
To lengthen the cable - Lift up on the cable and push up on the lock.
While keeping the lock depressed, lower the
cable to the desired length. Release the lock to set.
push
transformer
cord
cable
3217
3218
3219
Fig. B
splice box