Installation Sheet

Important: Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

Assembly Instructions for item : 3894LED, 3895LED

C-Shell Series - 4-Light LED Bath Bar, 5-Light LED Bath Bar

This light should be installed by a licensed electrician

LAMP INSTALLATION AND ASSEMBLY

1. Shut off power to the outlet box. (ﬁg. A)

2. Attach the mounting plate to the outlet box, secure with outlet box screws.

Use anchors and wood screws for extra support (included)

3. Make appropriate electrical connections using wire nuts:

a. Connect the ﬁxture’s live wire (black) to the live outlet box wire.

b. Connect the ﬁxture’s neutral wire (white) to the neutral outlet box wire.

c. Connect ﬁxture’s ground wire (green or uncoated) to the ground outlet

box wire. If no ground is present in outlet box, connect ﬁxture’s ground

wire to the mounting plate using the green screw (included).

d. Carefully place connections in outlet box.

4. Attach the back plate to the mounting plate, secure with cap nuts.

5. Place the glass between the glass holder and the spring clip, and ensure glass is set into the

slot on glass holder.

6. Restore power to the ﬁxture.

CARE INSTRUCTIONS

Dusting – Use a clean, dry cloth.

Cleaning – To protect the ﬁnish,

avoid any harsh abrasives or chemicals.

outlet box

back plate

mounting plate

outlet box screw

cap nut

glass

3895LED

3894LED

glass holder

slot

spring clip

anchor

wood screw

NOTE: This fixture is dimmable with Electronic

Low Voltage (Trailing-Edge) and

Incandescent (Leading-Edge) type dimmers.

For best performance, we recommend

using an Electronic Low Voltage dimmer.

PAGE 1
Assembly Instructions for item : 3894LED, 3895LED C-Shell Series - 4-Light LED Bath Bar, 5-Light LED Bath Bar Important: Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance. This light should be installed by a licensed electrician LAMP INSTALLATION AND ASSEMBLY 1. Shut off power to the outlet box. (fig. A) 2. Attach the mounting plate to the outlet box, secure with outlet box screws. Use anchors and wood screws for extra support (included) 3.