Installation Sheet

Important: Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

Assembly Instructions for item : 4840

Teardrop Series - 1- light Pendant

This light should be installed by a licensed electrician

OFF

LAMP INSTALLATION AND ASSEMBLY

1. Shut off power to the outlet box. (Fig A.)

2. Install Philips T10 bulb. (not included)

3. Position glass shade over socket cup,aligning the holes in the glass

shade with the threaded holes in the socket cup. Secure glass shade

with the three threaded pins.

4.Loosen strain relief in the canopy to adjust length of cable. Be

sure to tie knot for the SVT wire in canopy and secure the strain

relief once the desired length is obtained.

5. Attach mounting plate to outlet box using outlet box screws.

6.Make appropriate electrical connections using wire nuts:

a.Connect the fixture’s live wire (black) to the live outlet box wire.

b.Connect the fixture’s neutral wire (white) to the neutral outlet box wire.

c.Connect fixture’s ground wire (green or uncoated) to the ground outlet

box wire. If no ground is present in outlet box, connect fixture’s ground

wire to the mounting plate using the green screw (included).

d. Carefully place connections in outlet box.

7. Attach canopy over outlet box,tighten with canopy nuts.

8. Restore power to fixture.

CARE INSTRUCTIONS

Dusting – Use a clean, dry cloth.

Cleaning – To protect the finish,

avoid any harsh abrasives or chemicals.

outlet box

mounting plate

canopy

canopy nuts

threaded pins

socket cup

glass shade

Philips T10 bulb

canopy screws

outlet box screws

knot

SVT wire