Installation Sheet

Important: Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.
Assembly Instructions for item : 4843,4845,4848
Teardrop Series - 3/5/8 - light Pendant
©2009 SONNEMAN - A WAY OF LIGHT
This light should be installed by a licensed electrician
LAMP INSTALLATION AND ASSEMBLY
1. Shut off power to the outlet box. (Fig A.)
2. Install Philips T10 bulbs (not included)
3. Position glass shade over socket cup,aligning the holes in the
glass shade with the threaded holes in the socket cup. Secure glass
shade with the three threaded pins.
4.Loosen strain relief in the canopy to adjust length of cable. Be
sure to tie knots for the SVT wires in the canopy and secure the strain
relief once the desired length is obtained.
5. Mount gem bar to outlet box using outlet box screws.
6.Make appropriate electrical connections using wire nuts:
a.Connect the fixture’s live wire (black) to the live outlet box wire.
b.Connect the fixture’s neutral wire (white) to the neutral outlet box wire.
c.Connect fixture’s ground wire (green or uncoated) to the ground outlet
box wire. If no ground is present in outlet box, connect fixture’s ground
wire to the mounting plate using the green screw (included).
d. Carefully place connections in outlet box.
7. Attach canopy over outlet box threaded stem,tighten with canopy nut.
8. Restore power to fixture.
CARE INSTRUCTIONS
Dusting – Use a clean, dry cloth.
Cleaning – To protect the finish,
avoid any harsh abrasives or chemicals.
outlet box
gem bar
canopy
canopy nut
threaded pins
socket cup
glass shade
outlet box screws
outlet box
threaded stem
Philips T10 bulb
4848
4845
4843
knot
OFF
OFF
SVT wire

Summary of content (1 pages)