Installation Guide

2 of 2

October 20, 2016

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

REALS Series - LED Surface Mount

Important

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

1. Shut off power to the outlet box (A).

2. Make appropriate electrical connections using wire nuts:

a. Connect the LED driver’s (B) live wire (black) to the

live outlet box wire.

b. Connect the LED driver’s (B) neutral wire (white) to the

neutral outlet box wire.

c. Connect the xture’s ground wire (green or uncoated) to

the ground outlet box wire. If not ground is present in

outlet box, connect xture’s ground wire to the

mounting plate (C) using the green screw (included).

d. Carefully place connections and LED driver (B)

in outlet box (A).

3. Attach the mounting plate (C) to the outlet box (A), secure

with outlet box screws (D).

4. Install the xture (E) to the mounting plate (C). Secure with the

cap screws (F) using the included Allen wrench (G).

WARNING: Do not touch or press on the LEDs inside the

xture, or they will be damaged.

5. For Wet Location Use: Place a small bead of silicone or

water proof caulk (not included) around the xture (E)

where it comes in contact with the mounting surface.

6. Screw the lens (H) to the bottom of the xture (E).

For the Plate Lens, tighten using the included tool (J).

7. Restore power to the xture.

Note

• The outlet box must be at least 4” DIA and 1.5” deep to t the LED driver.

• This xture is dimmable with Electronic Low Voltage (Trailing-Edge) type and Incandescent (Leading-Edge) type

dimmers. For best performace, we recommend using an Electronic Low Voltage dimmer.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.

7309

DL - Dome Lens

FH - Clear

Cylinder Lens

FW - White

Cylinder Lens

PL - Plate Lens