Installation & Assembly

Important: Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.
Assembly Instructions for item : 2609
©2014 SONNEMAN - A WAY OF LIGHT
This light should be installed by a licensed electrician
LAMP INSTALLATION AND ASSEMBLY
1. Shut off power to the outlet box. (fig. A)
2. Attach the mounting cover to the outlet box, secure with outlet box screws.
3. Attach the safety hook in the canopy to one of the holes on the mounting cover.
4. Make appropriate electrical connections using wire nuts:
a. Connect the LED driver’s live wire (black) to the live outlet box wire.
b. Connect the LED driver’s neutral wire (white) to the neutral outlet box wire.
c. Connect fixture’s ground wire (green or uncoated) to the ground outlet
box wire. If no ground is present in outlet box, connect fixture’s ground
wire to the mounting plate using the green screw (included).
d. Carefully place connections in outlet box.
5. Install the canopy to the mounting cover by inserting the pins on the canopy
into the slots on the mounting cover. Twist the canopy clockwise to lock.
6. Restore power to the fixture.
CARE INSTRUCTIONS
Dusting – Use a clean, dry cloth.
Cleaning – To protect the finish,
avoid any harsh abrasives or chemicals.
NOTE: This fixture is controlled by the
included IR remote control, which must
be aimed at the sensor in the center of
the canopy. The fixture may be turned
on/off by a wall switch, but do not use
with a wall dimmer, or damage will occur.
Chromaglo
TM
Spectrum Series - Round Semi-Flush
outlet box
canopy
mounting cover
outlet box screw
slot
pin
LED driver
safety hook