Operation Manual

58
EN
Fig. 7
– Insert the power plug into a grounded AC220-240V/50Hz socket.
– As shown in Fig. 6, connect the drain hose well (only applicable for using a heating model).
– The dehumidifi er/air conditioner shall be installed on a fl at surface and with empty space all around. Do
not block the air outlet, and make sure the distance around the device is at least 30 cm.
Exhaust hose installation
1. Twist both ends of the exhaust hose into the square fi xing clip and the fl at fi xing clip.
2. Insert the square fi xing clip into the openings on the back of the air conditioner (Fig. 7)
3. Put the other end of the exhaust hose near the window sill.
Operating temperature range
Maximum cooling Minimum cooling
DB/WB (° C) 35/24 18/12
Caution for cooling and dehumidifying operations:
- When using the cooling and dehumidifying functions, wait for at least 3 minutes between each ON/OFF.
- Make sure the power supply meets the requirements.
- Ensure the socket is suitable for AC.
- Do not share one socket with other appliances.
- Ensure the power supply is AC220-240V, 50Hz
Cooling operation
• Press the «Mode» button (4) fi no a quando il simbolo «Cool» si appears.
• Press the button „Up“ (6) or „Down“ (5) to select a desired room temperature
• (16° C – 31° C).
• Press the «speed» (7) button to select the wind speed.
Dehumidifying operation
• Press the «Mode» (4) button until the “Dehum” icon appears.
• The selected temperature is automatically set to the current room temperature
minus 2° C (16° C – 31° C).
• The fan motor is automatically set to low wind speed.
Fan operation
• Press the «Mode» button (4) until the «Fan» icon appears.
• Press the «Speed» (7) button to select the wind speed.