Operation Manual

35
1 Safety instructions
Place FRESH CUBE on a raised surface such as a table, desk or counter top. This is the best
way to cool your personal area faster.
Let the filter absorb water for at least 3 minutes after filling the tank and before use. Doing
so will get you the coolest air quicker.
Try to stay within a few feet of FRESH CUBE. You’ll feel the most benefit when sitting
directly in front of the device.
FRESH CUBE will run for approximately 8 hours on a single fill on Low fan speed. Even
if the water tank is empty, the filter is still damp and FRESH CUBE can continue cooling.
Do not damage the cord by winding it around sharp corners, twisting it, resting heavy
objects on it, positioning it close to hot surfaces or allowing it to hang from the edge of
a table.
Do not immerse in water or other liquids.
Do not operate near a heater.
Do not use near flammable gases such as natural gas or propane.
Do not use near flames, kitchen appliances or heating appliances or, more generally, a hot
surface.
Do not put fingers and/or any objects in the air inlet/outlet grilles.
Do not place objects on top of the appliance.
Do not carry the device when filled with water. Some water may remain in unit even if
tank is empty.
Use only clean water. If needed, use distilled water.
Please read and follow regular maintenance as recommended in this guide.
The device works best in non-polluted areas. Large dust/dirt particles may reduce lifetime
of unit.
We recommend use only in dry locations. If using in a moist area or environment, take care
not to get water on external areas of the product.
If a leak or spill occurs on the surface of device, unplug the device and let it dry for 24
hours. Use it as you normally would afterwards.
Do not place in direct sunlight for extended periods of time.
Before not using the device for extended periods of time, empty the water tank, turn unit
on, and set to highest fan speed for at least 4 hours. This will dry out the filter and inside
of your unit.
Only use the original power adaptor and cord supplied in package.
Unplug the device when cleaning, removing/replacing filter, or moving this device.
For best results, place the device on a higher surface like a table or countertop.
Do not place the device near a heater or any electrical appliance.
Do not place the device in passageways or high traffic areas where there is possibility of
tripping or knocking it over.
Do not allow any foreign objects inside the device.
Do not place items on top of the device.
Do not block the front and back grills of the device.
Do not turn the device upside down.
Do not submerge the the device under water or other liquids.
Do not place the device near open flames or fire sources.
EN