Manual

1. Remove and set aside the two screws securing the
Thunderbolt interface card to the inner assembly
(Figure A-1).
2. Gently push down on the edge of the card to disengage the
card from its slot (Figure A-1).
3. Grasping the card by its edges, rotate the card out of the
inner assembly, and then pull it out (Figure A-2). Set aside
the Thunderbolt interface card on flat surface, component
side down.
4. Insert the BNC cables through the BNC connector
mounting holes in the inner assembly (Figure A-3). Route
the cables out over the top of the PCIe slot riser card.
5. Slide the connector nuts over the BNC cables, and then
secure the connectors to the inner assembly (Figure A-3).
6. Grasping the Thunderbolt interface card by its edges, insert
the card back into the inner assembly (Figure A-4).
7. Line up the card’s connector with the slot, and then gently
but firmly press the card straight into the slot; do not rock
the card or force the card into the slot. If you encounter
excessive resistance, check the card’s connector and the
slot for damage, and then try inserting the card again
(Figure A-5).
8. Using the two screws you removed previously, secure the
Thunderbolt interface card to the inner assembly; do not
overtighten the screws (Figure A-5).
9. Return to step 12 on page 6 to complete the PCIe card and
chassis setup steps.
Appendix A – BNC Connector Installation Steps
A
Figure A-1 Figure A-4
Figure A-2 Figure A-5
Figure A-3