User's Manual

Rev.1.01
2022. 03.
9 / 96
Doc # : BN-SM-EOP-01
direct sunlight, or a heater is near the product; that are frequently exposed to vibration;
that are too dusty or are not properly ventilated; or where chemicals or gases are
present. Do not place anything on top of the instrument.
- The product shall be operated in undisturbed conditions to avoid data transmission
interruption.
- When there is wireless channel congestion, switch the channel (Refer to Section 3.6
SETTINGS), and then restart the probe.
- Prescription Use. This product must only be used by persons who have sufficient
knowledge of and/or a qualification in clinical pathology. Unqualified operators are
prohibited from using the product.
- The product shall be repaired by professional recognized by Bionet.
- The product does not have shelf life. Its expected use life is 10 years. After 10 years,
though the product still works normally, it is recommended to have it checked by
Bionet.
- Useless components must be disposed of in compliance with local regulations.
- Be careful when holding the device, for the device is handheld, it may fall.
- The words “Insufficient Storage Space” will appear on the interface to remind the user
to clean up space when storage space will be insufficient.
Warnings:
- Never use the product in the presence of flammable or anesthetic gas. Doing so may
cause an explosion.
- Do not allow the interior of the product to be exposed to, or immersed in, liquid.
Otherwise, fire, electric shock, injury, or damage to the product may occur.
- Changes or Modifications not expressly approved by the party responsible could void
the user’s authority to operate this device.
- If the product does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the product and receiver.
 Connect the product into an outlet on a circuit different from that to which the
receiver is connected.