User Manual

36 © sonoro audio GmbH 2021
13. Attaching and detaching the AC
adapter’s power plug
WARNING!
Risk of electric shock!
• Do not insert power plug alone to the AC
inlet socket.
• Make sure plug and adapter are locked
thoroughly.
Attaching the power plug
• Pull down the clip and hold it.
• Match the round corner of plug to the
adapter.
• Insert the desired power plug vertically into
the contact pins of the adapter until it
completely pushes inward.
• Release the clip and lock the power adapter
in place.
Detaching the power plug
• Pull down the clip and hold it.
• Pull the power plug vertically out of the power
supply.
4.
Connecting PLATINUM SE
Note:
• The mounted Nagaoka MP-110 cartridge is a
MM cartridge, so please set your audio
system to MM (not MC).
• Make sure the audio system / amplifier you
connected to PLATINUM SE is switched off
and its volume set low.
• Before turning on your audio system and
PLATINUM SE, make sure all connections are
made properly, and you choose the right pre-
amplifier setting.
• Failures in doing so may lead into loud hum
noise which may damage your audio system
or speakers.
1. Connecting to an audio system /
amplifier
• Connect your audio system and PLATINUM
SE by using the delivered RCA cable.
• If your audio system has a built-in phono
amplifier, there most probably will be a
grounding terminal. Please screw the
grounding cables on both sides: Your audio
system and PLATINUM SE. As well plug the
RCA plugs into the phono input of your audio
system and the output of PLATINUM SE.
Note:
• The ground terminal of PLATINUM SE is not a
safety ground connection.
• Depending on the amplifier, connecting the
ground terminal might have the reverse effect
of increasing noise. In this case, it is not
necessary to connect the ground terminal.
• It is not recommended to connect PLATINUM
SE’s phono ground to MAESTRO’s phono
ground plate.
Round head