Owner's Manual

3
5. Slide the speaker onto the bracket and firmly snap into place
at the top and bottom of speaker. Pull enough wire through the
front of the speaker to allow connection to the terminals (see
figure 7).
6. Connect the speaker wires to the speaker’s terminals:
• Strip about .5” of insulation from each conductor and twist the
strands together or tin them with solder.
• Press-down on the tops of the connectors to open them.
• Insert the wires into the connector holes(see figure 8).
• Release the connectors.
• The binding post connectors can accept wire up to 14 gauge.
• Double-check that you connected all of the wires properly
(amplifier ‘+’ to speaker ‘+’; amplifier ‘–’ to speaker ‘–’) at
all connections.
Figure 7: Attach Speakers to Brackets
Figure 8: Connection Terminals
7. Fit the wiring connector cover into the recess in the speaker’s
front panel. The cover should fit tightly, but can be removed if
the speaker needs to be disconnected (see figure 9).
8. Fit the grille onto the speaker by aligning the edges of the grille
with the groove of the speaker face perimeter and pressing
firmly until it is snugly in place (see figure 10). Start by inserting
and pressing along the long edge, then insert one of the short
edges. Continue with the other long edge, and finally the other
short edge.
Figure 9: Attach the
Connector Cover
Figure 10: Attach the
Grille
UNLOCK (towards rear of speaker)
LOCK (towards front of speaker)
Figure 11: Lock and Unlock Slide Locks to Pivot Speaker
NOTE: ALL SONOS OUTDOOR BY SONANCE SPEAKERS ARE COMPATIBLE WITH OMNIMOUNT STAINLESS
STEEL 15.0 C AND 15.0 W SERIES SPEAKER BRACKETS. FOR MORE INFORMATION CONTACT YOUR
SONOS AUTHORIZED DEALER OR GO TO WWW.OMNIMOUNT.COM.
Pivoting the Speaker
You can rotate the speaker in the bracket to direct the sound
towards the listening area.
1. Unlock the slide locks on the speaker pivots by moving them
towards the rear of the speaker as indicated by the unlock
symbol (see figure 11).
2. Rotate the speakers to the desired position.
3. Lock the slide locks by moving them towards the front of
the speaker as indicated by the lock symbol (see figure 11).
NOTE: BE SURE THAT THE BRACKET CLIPS SNAP COMPLETELY INTO PLACE TO PREVENT ANY
BLOCKAGE WITHIN THE SPEAKER PERIMETER WHERE THE GRILLE IS TO BE INSERTED. PULL THE
SPEAKER GENTLY TOWARD YOURSELF TO VERIFY THAT IT IS SECURELY IN PLACE.
Removing the Speaker
To remove the speaker from the FastMount bracket, gently pull
the grille from each corner until it is freed from the grooves of
the speaker face. Once the grille is removed, remove the wire
connector cover and disconnect the speaker wire from the spring
loaded terminals. Next, use your thumbs to press outward on the
top and bottom tabs of the speaker face, releasing the clips of
the bracket. While pressing the tabs, pull gently on the speaker
away from the bracket.
IMPORTANT: BE SURE NOT TO LET ANY STRAY ‘+’ AND ‘–’ WIRES TOUCH EACH OTHER. TOUCHING
WIRES CAN CAUSE A SHORT-CIRCUIT THAT COULD DAMAGE YOUR AMPLIFIER.
Unlocking SONOS Audio
Enhancements
SONOS OUTDOOR by SONANCE speakers include exclusive
audio enhancements when used with a SONOS Amp. Use the free
SONOS app to unlock them.
Audio enhancements include:
• Custom EQ settings
• Gain adjustment
• Dynamic bass extension
• Signal limiting/loudspeaker protection