Installation Instructions

USA
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• All Sonos devices have in-products antennas. Users cannot reorient or relocate the
receiving antenna without modifying the product
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Caution: Modifications not expressly approved by the manufacturer may void the user's
authority to operate the equipment under FCC rules.
Canada
This Class B digital apparatus complies with Canadian ISED RSS standards. Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation
of the device.
The installer of this radio equipment must ensure that the product is located such that it does
not emit RF field in excess of Health Canada limits for the general population; consult Safety
Code 6, obtainable from Health Canada’s Web site www.hc-sc.gc.ca/rpb. As mentioned before,
the installer cannot control the antenna orientation. However, they could place the complete
product in a way that causes the problem mentioned above.
The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems. Be advised that high-
power radars are allocated as primary users (i.e. priority users) of the bands 5250- 5350 MHz
and 5650-5850 MHz and that these radars could cause interference and/or damage to LE LAN
devices.
Canada
Cet appareil numérique de classe B est conforme aux normes ISED RSS en vigueur au
Canada. Son fonctionnement est soumis aux deux conditions suivantes : (1) Cet appareil ne
doit pas créer d'interférences nuisibles. (2) Cet appareil doit tolérer toutes les interférences
reçues, y compris les interférences pouvant entraîner un fonctionnement indésirable.
L'installateur du présentmatérielradiodoitveiller à ce que le produitsoitplacé ou orient de manière
à n'émettreaucunchampradioélectriquesupérieur aux limitesfixéespour le grandpublicpar le
ministère fédéral Santé Canada; consultez le Code de sécurité 6 sur le site Web de Santé
Canada à l'adresse : www.hc-sc.gc.ca/rpb. Comme indiqué auparavant, l'installateur ne peut
pas contrôler l'orientation de l'antenne. Il peutnéanmoinsplacer le produittoutentier de manière à
provoquer le problèmedécritci- dessus.