User's Guide

8
Caution
In the event of any of the above anomalies, the ultrasound
imaging diagnostic apparatus may be defective, please contact
SonoStar.
The Wireless Connection Indicator and the Battery Capacity Indicator on the probe may be
invisible before the probe is turned on.
Press the button to turn on the probe. The Battery Capacity Indicator will be light to indicate
the capacity of the battery. The four grids of the indicator imply the battery capacity. (Probe charging
will be described in section 4.)
Seconds after the probe turned on, the Wireless Connection Indicator will be light and blinking
to notice that the probe is ready for a wireless connection from the iPad or iphone.
The probe can be turned off by hold down the button for seconds. When the probe is off, the
indicators will be turned off.
2.4 WIRELESS CONNECTION
When the probe is waiting for a wireless connection as described in previously, launch the
Settings of iPad or iPhone, turn on the Wi-Fi (if not on), Find the SSID of the probe. The SSID is like:
“SS-1 GMBFCA001”, the suffix “GMBFCA001” is a code generated from Serial Number. Connect to
the SSID with the password same as the Serial Number (in lower case). The Serial Number is in the
form like “WSPBFCA001” with the prefix of “WSP”. It can be found on the surface of the probe.
After Wi-Fi is connected, launch the WirelessScan App, after the connection from the app to
the probe is confirmed, the Wireless Connection Indicator on the probe will be light with no
blinking.
Every connection steps are done. The operations of using the system to finish ultrasonography
task will be described in the next section.