User's Guide

18
4.3 CLEANING AND DISINFECTION
The probe needs to be cleaned before using.
To clean the probe, Use a soft cloth dampened with isopropyl alcohol (or an appropriate
hospital cleaning agent) to wipe the Probe until it is thoroughly cleaned.
If you use a detergent solution to clean the instrument, remove all residual detergent. Dry
the instrument with a clean, soft cloth.
Alternatively, dampen a soft cloth in any glutaraldehyde-based hospital disinfectant solution
such as Cidex. Wipe the instrument with the dampened cloth.
To remove all traces of disinfectant solution, wipe the instrument with a clean soft cloth
dampened in sterile water or potable tap water. Wiping the device three separate times to
remove all residual disinfectant is recommended
Thoroughly dry the instrument with a clean, soft cloth before using.
4.4 STORAGE
When not in use, it is recommended that the equipment should be put in the case. While
stored, the equipment should be protected from temperature extremes.
4.5TROUBLE SHOOTING
Inspect: check if the probe and the host is properly connected.
Fault handling:
Ite
m
Failure Prolem
Solution
1
No response after press the power
switch
Charging,check the power supply
2
Intelligent display can't connect
probe WIFI
Check the WIFI signal channel is ready;
test whether the WIFI password input is correct
3
Displayed on the screen with
interference like snow
Check if other equipment started which cause
electromagnetic interference,shut down the
device or get far from the device.
4
The image not bright
Adjust brightness
5
Charging not work
Detect circuit and electrical outlet, check if
the USB interface is damaged
4.6Disposal
*Warning: products should not be discarded at will.
-Battery recycling meets local requirements.
-Recycling of waste electrical and electronic products should comply with local laws
and regulations.