User Manual

Voluum © Copyright 2014 Sonuus Limited 21
Owner’s Manual
The parameters are shown in the table below:
The compressor effect can be a subtle smoothing-out of your sound (CPr set to a low value, and thr
set to a high value), or can be used to add a distinct “compressed sound” to your playing (set CPr to
a high value and thr to a low value).
The attack parameter (Att) is the time in milliseconds that it takes the compressor to respond to a
signal that exceeds the threshold. A fast attack (Att time is small) can compress short transients,
Parameter Controllable Range Description
CPr yes 0–100
Compression amount.
0 is subtle (soft-knee, low ratio),
100 is maximum compression (hard-knee, high ratio).
thr yes −60–20 Threshold in dB.
Att yes 0–100 Attack time in milliseconds.
rEL yes 0·10–6·00 Release time in seconds.
LvL no −24–24
Level trim in dB. Use this to keep the signal level the same
regardless of the amount of compression being applied.
CtL no 0–127
MIDI controller for compress. Only available if MIDI control
is selected for the compressor effect.