User Manual

32 © Copyright 2014 Sonuus Limited Vo l u um
Owner’s Manual
MIDI input (from computer or MIDI device to Voluum)
The Voluum can also be used as a USB - MIDI interface, allowing you to send MIDI between your
computer and other
MIDI gear. When the Voluum is connected to your computer via USB , any MIDI
messages sent to the V oluum over USB will also be sent out the 5-pin MIDI output. Similarly, MIDI
received on the 5-pin MIDI input will be sent over USB to your computer.
MIDI message Chan Description
MIDI sync
MIDI clock
N/A Used when LFO is in MIDI sync (Syn) mode.
Song position
Program Change
Program Change
Ch. i
a
a. MIDI input channel, Ch.i, selected in custom parameters.
Selects the preset to be used. Operates on the currently
selected bank (factory or user). Use Bank Select
controller message to switch between factory and user
banks.
Controllers MSB LSB
Bank Select #0 #32 Ch. i
Selects factory (0) or user (1) preset bank.
(Factory: #0=0, #32=0. User: #0=0, #32=1.)
compressor #11 #43 Ch. i
This is the default (expression). It can be changed in the
compress parameters.
LFO #1 #33 Ch. i
This is the default (modwheel). It can be changed in the
LFO parameters.
volume #7 #39 Ch. i
This is the default (volume). It can be changed in the
volume parameters.
limiter #12 #44 Ch. i
This is the default (effect control 1). It can be changed in
the limiter parameters.