User Manual

34 © Copyright 2014 Sonuus Limited Vo l u um
Owner’s Manual
P. En on
oFF
on
o.Lo
o.hi
Pedal enable. Allows you to enable the effect by moving the
footpedal. If set to oFF then this feature is disabled.
The effect is enabled when the footpedal is pressed to the toe-
down position. The effect must be turned off using the footswitch.
On/off low (heel): the effect is enabled when the footpedal is in
the heel-down position, and is deactivated when the footpedal
returns to this position (after a time set by “pedal effect off time”).
On/off high (toe): the effect is enabled when the footpedal is in the
toe-down position, and is deactivated when the footpedal returns
to this position (after a time set by “pedal effect off time”).
Setting P. En to o.Lo or o.hi affects how footpedal preset selection
works—see “Foot-operated preset selection” on page 13.
P. ti 0·1 0·1–20·0
Pedal effect time off. Only available if P. E n is set to o.Lo, or o.hi.
When P. En is set to o.Lo, or o.hi, this sets the time (in seconds)
that the footpedal must be in the “off” position before the effect is
turned off.
FS.t 4 (2s) oFF, 1–8
Footswitch time. Time in 500ms steps that footswitch is held to
enter and exit foot-operated preset selection mode.
Po.t oFF
oFF,
1–240
Power-save timeout. This sets the time to enter a lower-power
state (display goes off) to prolong battery life when the effect isn't
enabled.
PoS oFF oFF, on
Show footpedal position. When set to on, =00–=99 is displayed
when the footpedal is moved. This can be used to position the
footpedal in a particular position before enabling the effect.
Ch.i 1
Any,
1–16
Sets the MIDI input channel used to receive MIDI messages. If set to
Any,
MIDI messages on any channel will be accepted (omni mode).
Ch.o 1
oFF,
1–16
Sets the MIDI output channel used to send MIDI messages. If set to
oFF, no
MIDI messages will be sent.
Parameter Default Range Description