User Manual

WAP 75
Password – your password to log on to the external data
network.
Passwd. request (Password request) – if this setting is
on, you are asked for a password each time you log on to
the external data network.
Allow calls – if you want to allow incoming
calls during a GPRS session, select
ON. If not,
select OFF.
IP address – the IP address that the phone uses when
communicating with the network. If you do not enter a
value, the network provides you with a temporary IP
address.
DNS (Domain name server) - the name that the server
translates into a number.
Basic settings (Basic settings) – these are optional.
Consult your network operator.
Settings for GSM data
Phone Number – the phone number of your Internet
service provider.
User id, Password, Passwd. request. Same as for GPRS
above.
Data rate – select the speed you want for the
connection.
Dial type – select analog or ISDN connection.
If you want to change access type, you have to create a
new data account and select the access type you want to
use.
GPRS and GSM Data Settings
If you have selected GPRS as the access type, the
Preferred service should be set to GPRS&GSM. An icon
may then appear in the display telling you that GPRS is
within range. See “Icons” on page 93. If you have
selected GSM data as the access type, you should select
GSM only as the preferred service. This setting is valid
for all data accounts.
To select a preferred service
1. Scroll to Settings, Data comm., Pref. service.
2. Select GPRS&GSM or GSM only.
Note!
Your service provider may provision your WAP
settings so they are not viewable on your phone.
Tip!
To see the status of GPRS coverage and
connection, press the upper or lower side volume
key from standby to enter the Status menu and
then scroll to GPRS.